Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Potential bug in impl of LOAD "..." CODE
Hi Boriel,

Thanks for the swift reply. I am able to load the UDGs, using the method that you suggest (and making sure my program does not extend into the UDG space). However, the routine that loads in the UDGs causes corruption in my program when it reads in a header from tape (not the actual data). The address calculated for holding the 17-byte tape-header information is in the middle of my program code, rather than in the heap area or, as is done in Sinclair BASIC, the workspace. I'm pretty sure this is a mistake.

Thanks again

Messages In This Thread
RE: Potential bug in impl of LOAD "..." CODE - by georgeo - 03-16-2021, 08:23 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)