Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PRINT AT 23,0 and FOR NEXT Loop not working after Fastcall
Luzie Wrote:I understand and have to check where my original BASIC program "runs out of screen".
However, one question:
When I have a program with this two lines:

PRINT AT 24,0;"24,0"
PRINT AT 10,0;"10,0"

I think a regular PRINT position should reset the "Out of Screen" flag ?
Unfortunately not. For speed reasons, only errors are "signaled". If a PRINT is ok, no flag is reset.

Messages In This Thread

Forum Jump:

Users browsing this thread: 1 Guest(s)